LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2013 >> Optima SXL >> Repair and Diagnosis >> Accessories & Equipment >> Mirrors >> Exterior Body Panels - Except HEV >> Trunk Lid >> Repair Procedures >> Replacement >> Trunk Lid Assembly Replacement

Trunk Lid Assembly Replacement

CAUTION:
  • When removing and installing the trunk lid, an assistant is necessary.
  • Wear gloves to protect hands from injury.
  1. Loosen the trunk inside handle (A) mounting screws.
    Fig 1: Trunk Inside Handle & Mounting Screws
    G07380173Courtesy of KIA MOTORS AMERICA, INC.
  2. Detach the clips, then remove the trunk lid trim (A).
    Fig 2: Trunk Lid Trim & Clips
    G07380174Courtesy of KIA MOTORS AMERICA, INC.
  3. Disconnect wiring (B) and connectors.
  4. After loosening the mounting bolts, then remove the trunk lid (A).

    Tightening torque: 

    6.9~8.8 N.m (0.7~0.9 kgf.m, 5.1~6.5 lb-ft)

    Fig 3: Trunk Lid & Wiring
    G07380175Courtesy of KIA MOTORS AMERICA, INC.
  5. Installation is the reverse of removal.
    NOTE:
    • Replace any damaged clips.
scientia non olet · About LEMON Manuals