GDS Data Analysis
- Connect GDS.
- IG "ON" and engine "OFF".
- Select "DTC Analysis" mode.
- After erase DTC, keep the vehicle condition within "the enable conditions" Refer to DTC DETECTING CONDITION table.
- Is the same DTC occurred again?
YES
- Go to next procedure.
NO
- Fault is intermittent caused by poor contact in the sensor's and/or SJB's connector or was repaired and SJB memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to VERIFICATION OF VEHICLE REPAIR procedure.
- Check Left External Tail Lamp
- IG "OFF" and connect scantool
- IG "ON" & ENG "OFF"
- Select "Actuation Test and current data" mode.
- Execute "Left External Tail Lamp" test.
- Is External Tail Lamp LH working normal?
YES
- Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to VERIFICATION OF VEHICLE REPAIR procedure.
NO
- Go to next procedure.