HPU connector input/output
| Connector Terminal | Specification | Remark | |
|---|---|---|---|
| No | Description | ||
| 3 | IGNITION1(+) | Over voltage range: 16.0 ± 0.5V Operating voltage range: 9.0 ± 0.5V < V < 16.0 ± 0.5V Low voltage range: 8.0 ± 0.5V < V < 9.5 ± 0.5V Max. current: I < 50mA |
|
| 2 | POS. BATTERY 1. (SOLENOID) | Operating voltage range: 9.0 ± 0.5V < V < 16.0 ± 0.5V Max. current: I < 500mA Max. current: I < 15A Max. leakage current: I < 0.3mA |
No AHB Control In AHB Control |
| 1 | POS. BATTERY 2. (MOTOR) | Operating voltage range: 9.0 ± 0.5V < V < 16.0 ± 0.5V Rush current: I < 110A Max. current: I < 40A Max. leakage current: I < 0.2mA |
Rush current Continuus current |
| 26 | GROUND | Rated current: I < 550mA Max. current: I < 15A |
In AHB Control |
| 25 | PUMP MOTOR GROUND | Rush current: I < 110A Max. current: I < 40A |
In AHB Control |
| 13 | CAN BUS LINE(LOW) | Max. Input current: I < 10mA | |
| 6 | CAN BUS LINE(HIGH) | ||
| 20 | CAN SENSOR LINE (HIGH) | Max. input current: I < 10mA | |
| 12 | CAN SENSOR LINE (LOW) | ||
| 14 | BRAKE LIGHT SWITCH | Input voltage (Low): V < 2V Input voltage (High): V > 6V Max. Input current: I < 3mA (@12.8V) |
|
| 21 | DOOR SWITCH(DRIVER) | ||
| 18 | PEDAL STROKE SENSOR POWER | Max. Output current: I < 30mA Max. Output voltage: 4.75V ≤ V ≤ 5.255V |
|
| 10 | PEDAL STROKE SENSOR GROUND | Max. Output current: I < 30mA | |
| 8 | PEDAL STROKE SENSOR GROUND | Min. Output voltage: 0.75 ± 0.05V Max. Output voltage: 4.1 ± 0.3V |
|