Outside Handle Replacement

Remove the front door trim.
Remove the front door module.
Remove the hole plug (B).
After loosening the mounting bolt, then remove the outside handle cover (A).
Tightening torque:

0.7 ~ 0.5 N.m (0.07 ~ 0.1 kgf.m, 1.0 ~ 0.7 lb-ft)

Fig 1: Identifying Outside Handle Cover And Hole Plug
Courtesy of KIA MOTORS AMERICA, INC.
Remove the outside handle (A) by sliding it rearward.

Fig 2: Removing Outside Handle
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the outside handle connector (A).

Fig 3: Identifying Outside Handle Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the door locks/unlocks and opens/closes properly.
- Make sure the door locks and opens properly.