Windshield Deicer Switch

Inspection

1. The windshield deicer switch inputs can be checked using the GDS.
2. To check the input value of windshield deicer switch, select option "Body Control Module".
3. Select option "Current Data of smart junction box".




4. To check the input value of windshield deicer switch in force mode, select option "Actuation Test of smart junction box".






Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the lower (A) after loosening the mounting screws.





3. Remove the heater control unit contained the windshield deicer switch from the center fascia lower panel.

Installation

1. Install the heater control unit.
2. Install the center fascia lower panel.
3. Install the crash pad garnish.