Cluster Fascia Replacement

NOTE:

When prying with a flat tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Insert the Air Vent Remover (09840-1M100) into the air vent hole.

Fig 1: Air Vent Hole
Courtesy of KIA MOTORS AMERICA, INC.
Air vent remover (09840-1M100 (A)) should be aligned and hung at the end of air vent.

Fig 2: Identifying Air Vent Remover Alignment
Courtesy of KIA MOTORS AMERICA, INC.
CAUTION:
- To prevent the damage of air vent, air vent remover should be aligned and hung at the end of air vent.
Remove the side air vent (B) with pulling the Air Vent Remover (A).

Fig 3: Removing Side Air Vent With Air Vent Remover
Courtesy of KIA MOTORS AMERICA, INC.
Set the air vent hole to the center with adjusting the knob.
Open the air vent with adjusting the knob.
Insert the Air Vent Remover (09840-1M100) into the air vent hole.

Fig 4: Air Vent Adjusting Knobs
Courtesy of KIA MOTORS AMERICA, INC.
Air vent remover (09840-1M100 (A)) should be aligned and hung at the end of air vent.

Fig 5: Air Vent Remover Alignment
Courtesy of KIA MOTORS AMERICA, INC.
Remove the center air vent (B) with pulling the Air Vent Remover (A).

Fig 6: Removing Center Air Vent With Air Vent Remover
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the center fascia panel (A).

Fig 7: Center Fascia Panel
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors.

Fig 8: Center Fascia Panel Connectors (1 Of 2)
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors (A).

Fig 9: Center Fascia Panel Connectors (2 Of 2)
Courtesy of KIA MOTORS AMERICA, INC.
Tilt the steering column down.
After removing the screws, remove the upper shroud cover (A).
After loosening the mounting screws, remove the cluster fascia panel (B).
Disconnect the connector (C).

Fig 10: Upper Shroud Cover, Cluster Fascia Panel & Connector
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the cluster fascia (A).

Fig 11: Cluster Fascia & Mounting Screws
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (A).

Fig 12: Cluster Fascia Connectors
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse the removal.

NOTE:

Make sure the connector is plugged in properly.