Center Fascia Panel Replacement

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Set the air vent hole to the center with adjusting the knob.
Open the air vent with adjusting the knob.
Insert the Air Vent Remover (09840-1M100) into the air vent hole.

Fig 1: Air Vent Adjusting Knobs
Courtesy of KIA MOTORS AMERICA, INC.
Air vent remover (09840-1M100 (A)) should be aligned and hung at the end of air vent.

Fig 2: Air Vent Remover Alignment
Courtesy of KIA MOTORS AMERICA, INC.
CAUTION:
- To prevent the damage of air vent, air vent remover should be aligned and hung at the end of air vent.
Remove the center air vent (B) with pulling the Air Vent Remover (A).

Fig 3: Removing Center Air Vent With Air Vent Remover
Courtesy of KIA MOTORS AMERICA, INC.
Remove the center fascia panel (A).

Fig 4: Center Fascia Panel
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (A).

Fig 5: Center Fascia Panel Connector
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the heater control unit connector (A).

Fig 6: Heater Control Unit Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.