Repair Procedures

Removal

1. Remove the rear wheel & tire.

Tightening torque :
88.3 - 107.9N.m (9.0 - 11.0kgf.m, 65.1 - 79.6lb-ft)


2. Loosen the hose eye-bolt (B) and caliper mounting bolts (C), then remove the rear caliper assembly (A).

Tightening torque
Brake hose to caliper(B):
24.5 - 29.4N.m (2.5 - 3.0kgf.m, 18.1 - 21.7lb-ft)
Caliper assembly to carrier(C):
63.7 - 73.6N.m (6.5 - 7.5kgf.m, 47.0 - 54.3lb-ft)





3. Remove the rear brake disc by loosening the screws (A).






Replacement

Rear Brake Pads
1. Loosen the guide rod bolt (B) and pivot the caliper up out of the way.

Tightening torque :
21.6 - 31.4N.m (2.2 - 3.2kgf.m, 15.9 - 23.1lb-ft)





2. Replace pad shim, pad retainers (C) and brake pads (B) in the caliper bracket (A).






Installation

1. Installation is the reverse of removal.
2. Use a SST (09581-11000) when installing the brake caliper assembly.
3. After installation, bleed the brake system.