Monitor DTC Status

P0441 Evaporative Emission System Incorrect Purge Flow

Scantool Diagnostics

Monitor DTC Status

1. Start engine to normal operating temperature.

NOTE:
Evaporative Emissions Systems (EVAP) Leak Tests can be run by the Scan Tool. The tests are automated and provide either a pass-fail result or directions to check for DTCs.

2. Install scan tool and clear DTC.
3. Perform "EVAP. LEAKAGE TEST" mode referring to enable conditions as below.

NOTE:
EVAP. Leakage Test enable conditions
- Following conditions must be fulfilled to start the test.
1. Engine warm up at Idle Status
2. No relevant DTC
3. Fuel level is below 80%

4. Is DTC P0441 set again?