Component Inspection

P0140 O2 Sensor Circuit No Activity Detected (Bank 1 / Sensor 2)

Inspection/Repair - Component Inspection

Component Inspection

1. Visually/physically inspect the following conditions:
'- Ensure that the sensor is securely installed
'- Check for corrosion on terminals
'- Check for damaged wiring
'- Repair as necessary and go to next step
2. Warm up the engine to normal operating temperature and let it idle.
3. Connect GDS and monitor the O2 SNSR VOL.-B1/S2 parameter on the GDS data list.

Specification :Above 0.7 V at idle

4. Is sensor data near the specified value?