General Information

C1261 Steering Angle Sensor Not Calibrated

General Information

Component Location





General Description

EPS CM controls EPS solenoid current accurately according to vehicle speed. EPS CM monitors that operating voltage supplied as IG S/W is too high or too low on "power supply terminal". If excessive high voltage or low voltage is detected, EPS CM stops current supply to solenoid to prevent unexpected operation or damage.

DTC Description

EPS CM sets this code if ASP (Absolute Steering Position) zero setting is not done when EPS CM losses steering angle signal due to EPS alignment replace etc. EPS CM stops "damper" and "return" control due to loss of steering angle signal.

DTC Detecting Condition