Clutch Pedal Assembly: Testing and Inspection

INSPECTION

1. Check the pedal shaft and bushing for wear.
2. Check the clutch pedal for bending or torsion.
3. Check the return spring for damage or deterioration.
4. Check the pedal pad for damage or wear.

Ignition lock switch inspection
Remove the ignition lock switch and check for continuity between the terminals. If the continuity is not as specified, replace the switch.





Standard value
Full stroke(A) : 12.0 ± 0.3mm (0.472 ± 0.012 in.)
ON-OFF point (B) : 2.0 ± 0.3mm (0.078 ± 0.012 in)