LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2008 >> Rio Base, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System >> Operation And Leakage Check >> Inspection Of Rear Disc Brake Pad

Inspection Of Rear Disc Brake Pad

  1. Check the brake pad thickness through the caliper body inspection hole.

    Pad thickness

    Standard value: 10.0 mm (0.39 in.)

    Service limit: 2.0 mm (0.0787 in.)

    Fig 1: Locating Rear Caliper Body Inspection Hole
    G04863158Courtesy of KIA MOTORS AMERICA, INC.
    CAUTION:
    • If the pad thickness is out of specification, left and right pads must be replaced as a complete set.
    • When the thickness difference between the left pad and right pad is large, check the sliding condition of the piston and the guide rod.
scientia non olet · About LEMON Manuals