Installation

INSTALLATION





1. Install the bushing on the stabilizer bar.

NOTE: After matching the bushing(D) in the inside of the white painted part(A) on the stabilizer bar(C), install the assembly.

2. Install the bracket(B) on the bushing(D).





3. Tighten the components below to the specified torque as follows.
Rear stabilizer bar mounting bracket bolts (A): 17 - 26 Nm (170 - 260 kgs-cm, 13 - 19 ft. lbs.)
Rear stabilizer bar link mounting nut (B): 35 - 45 Nm (350 - 450 kgs-cm, 26 - 33 ft. lbs.)