DTC 62: Driver PRETENSIONER Short To Battery
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Disconnect Air Bag Control Unit (ACU) connector and driver-side seat belt pretensioner connector. Check voltage between ground and terminals No. 1 (Light Green wire) and/or No. 2 (Orange wire) of ACU connector. See Figure. If battery voltage does not exist, go to next step. If battery voltage exists, replace harness between ACU and pretensioner.
- Check voltage between terminal No. 1 (Light Green wire) and terminal No. 2 (Orange wire) of pretensioner connector and ground. See WIRING DIAGRAMS . If voltage exists, replace harness between ACU and pretensioner. If voltage does not exist, replace seat belt pretensioner. See SEAT BELT PRETENSIONER under REMOVAL & INSTALLATION.