LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2003 >> Rio Base, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Master Cylinder >> Removal

Master Cylinder: Removal

  1. Disconnect low fluid level switch wiring connector.
  2. Disconnect brakelines from master cylinder and ABS control unit by using Flare Nut Wrench (0K130-430-019). Cap tubes and plug master cylinder ports and ABS control unit ports to prevent entry of contaminants.
  3. Remove 2 master cylinder attaching nuts and washers. See Figure . Remove master cylinder from mounting studs on brake booster.
scientia non olet · About LEMON Manuals