DTC B1354: Passenger-Side Air Bag Module Short To Ground

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Disconnect passenger-side air bag module and seat belt pretensioner connectors. Disconnect SRSCM connector. Go to next step.
Measure resistance between passenger-side air bag module harness connector high-side circuit terminal No. 13 (Orange wire) and ground at SRSCM connector. See Figure. If resistance is infinite, go to next step. If resistance is not infinite, replace wire harness between SRSCM and passenger-side air bag module. See WIRING DIAGRAMS .
NOTE: DTC's other than DTC B1354 may be retrieved by scan tool. They are not relevant to this test.
Connect passenger-side air bag module to harness connector. Connect SRSCM connector. Connect negative battery cable. Wait at least 30 seconds. Turn ignition on. Wait at least 30 seconds. Using scan tool, clear DTC's. Turn ignition off. Wait at least 30 seconds. Turn ignition on. Wait at least 30 seconds. Using scan tool, retrieve DTC's. If DTC B1354 is retrieved, replace passenger-side air bag module. See PASSENGER-SIDE AIR BAG MODULE under REMOVAL & INSTALLATION. If DTC B1354 is not retrieved, system is okay.