LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2002 >> Sedona EX >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Brake System Components >> Brake Booster Assembly >> Removal

Brake Booster Assembly: Removal

  1. Remove a battery.
  2. Disconnect the master cylinder electrical connector.
    CAUTION: Before removing the brake pipes and reserve tank from master cylinder, be sure they are clean to prevent dirt particles from entering the brake hydraulic system.
  3. Loosen the brake pipe flare nuts and disconnect the brake pipe from the brake master cylinder.
  4. On manual transaxle vehicles, remove the clamp and pull the clutch master cylinder hose from the master cylinder reserve tank.
  5. Cap the brake pipe and the brake master cylinder ports.
  6. Remove two nuts and lock washers and remove the master cylinder.
  7. Loosen the vacuum hose clamp and remove the vacuum booster hose from the power brake booster.
  8. From inside vehicle, remove the pin and discard it.
  9. Remove the clevis pin.
  10. Remove the four power brake booster nuts.
  11. Remove the power brake booster.
  12. Remove the power brake booster gasket and discard it.
scientia non olet · About LEMON Manuals