Parking Brake Lever: Installation

Feed rear parking cable end into backing plate and install its retaining clip.
Attach rear parking cable end to rear brake shoe and install brake assembly.
Attach rear parking cable to trailing link and floor pan with bolt and two nuts, and tighten to specification.
1. Tightening torque:
  1. Bolts: 5.25~7.5 lb.ft (7~10 N.m, 0.7~1.0 kg.m)
  2. Nuts: 14~19 lb.ft (19~26 N.m, 1.9~2.6 kg.m)
Attach forward end of rear parking cable to floor pan with a push-on clip.
If front cable assembly was removed, insert its forward end through grommet and connect rear brake cable to front parking cable's balance bar.
From inside vehicle, insert front cable end into parking brake lever assembly and install cable adjuster nut.
Fasten cable adjuster with its clip.
If removed, install parking brake switch with its screw.
Attach lever assembly to floor pan with two bolts. Tighten bolts to specification.
Tightening torque: 14~19 lb.ft (19~26 N.m, 1.9~2.6 kg.m)
Adjust parking brake. See INSPECTION .
Install console and tighten two bolts and four screws.
Install cigarette lighter connector and center console.
Install gearshift lever knob.
NOTE: Turn ignition switch ON and check that parking brake warning lamp illuminates with lever pulled back one notch.