LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2001 >> Sephia Base, Automatic >> Repair and Diagnosis (Single Page) >> General Information >> Restraints >> Air Bag Deactivation Procedures >> HONDA >> Disabling & Activating Air Bag System >> Activating Air Bag System (Civic)

Activating Air Bag System (Civic)

NOTE: To reconnect front SRS connectors, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together, pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and connector will lock.
  1. Ensure ignition is OFF and negative battery cable is disconnected. Wait at least 3 MINUTES. Connect 2-pin driver air bag connector. Install access panel.
  2. Connect 4-pin passenger air bag connector. Install glove box. Connect driver and passenger side impact air bag module 2-pin connectors under seats.
  3. Connect both front seat belt pretensioner 2-pin connectors to SRS main harness. Install trim panels. Connect both seat belt buckle tensioner connectors to SRS main harness.
  4. Reconnect negative battery cable. Check SRS indicator light to ensure system is functioning properly. See SYSTEM OPERATION CHECK . Reprogram radio frequencies.
Fig 1: Disabling Passenger Air Bag (Civic)
G00018836Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Disabling Seat Belt Pretensioner (Civic)
G00018837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 3: Disabling Seat Belt Buckle Tensioner (Civic)
G00018838Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals