LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2001 >> Sephia Base, Automatic >> Repair and Diagnosis (Single Page) >> General Information >> Restraints >> Air Bag Deactivation Procedures >> ACURA >> Disabling & Activating Air Bag System >> Activating Air Bag System (MDX)

Activating Air Bag System (MDX)

NOTE: To reconnect front SRS connector, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together, pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and lock connector.
  1. Ensure ignition is OFF and negative battery cable is disconnected for at least 3 minutes. Connect 2-pin driver air bag module connector to cable reel connector. Install access panel under steering wheel.
  2. Connect passenger air bag module connector to SRS harness connector. Install glove box. Connect both front seat belt pretensioner 2-pin connectors to SRS main harness. Install trim panels. Connect driver and passenger side impact air bag module 2-pin connectors under seats.
  3. Ensure ignition is off. Connect negative battery cable. Ensure air bag system is functioning properly. See SYSTEM OPERATION CHECK . Reset radio anti-theft code and preset radio frequencies
scientia non olet · About LEMON Manuals