DTC 61: Driver PRETENSIONER Short To Ground
NOTE:
Refer to wiring diagram and Air Bag Diagnostic Unit (ADU) connector identification when diagnosing faults. See Figure & Figure
.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Disconnect Air Bag Diagnostic Unit (ADU) connector and driver-side seat belt pretensioner connector. See WIRING DIAGRAMS . Check for continuity between ground and ADU connector terminal No. 1 (Light Green wire) and-or terminal No. 2 (Orange wire). See WIRING DIAGRAMS . If continuity exists, replace harness between ADU and pretensioner. If continuity does not exist, go to next step.
- Check for continuity between ground and seat belt pretensioner harness connector terminals No. 1 (Light Green wire) and-or No. 2 (Orange wire). If continuity exists, replace harness between ADU and pretensioner. If continuity does not exist, replace pretensioner. See SEAT BELT PRETENSIONER under REMOVAL & INSTALLATION.