LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2001 >> Rio Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Parking Brake System >> Adjustment >> Installation

Parking Brake System: Adjustment: Installation

  1. Position the end of the cable through the body hole.
  2. Put the parking brake cable into the back plate.
  3. Install the parking brake cable on the brake shoe assembly.
  4. Install the drum assembly (refer to REAR DRUM BRAKE  ).
  5. Install the parking brake cable attaching nut and bolt.

    Tightening torque: 19~26 N.m (19~26 kg/cm, 14~19 lb-ft) 

  6. Install the wheel and tire assemblies.
  7. Lower the vehicle.
  8. Install the parking brake cable cover.

    Tightening torque: 19~26 N.m (19~26 kg/cm, 14~19 lb-ft) 

  9. Install the rear cable attaching bracket.

    Tightening torque: 19~26 N.m (19~26 kg/cm, 14~19 lb-ft) 

  10. Install the rear cable attaching bracket.
  11. Install the rear carpet and rear side-door trim.
  12. Install the rear seat.

    Tightening torque: 19~26 N.m (19~26 kg/cm, 14~19 lb-ft) 

  13. Secure the cable with the pin after connecting the front cable with the rear cable.
  14. Install the parking brake lever.

    Tightening torque: 19~26 N.m (19~26 kg/cm, 14~19 lb-ft) 

  15. Route the end of the cable through the parking brake lever and then properly tighten the cable adjuster nut.
  16. Install the parking brake indicator lamp switch.
  17. Install the parking brake console.
NOTE: Check that the stroke is within specification. Check that the parking brake warning lamp illuminates when pulling the brake lever back one notch.
scientia non olet · About LEMON Manuals