LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2000 >> Spectra GS, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> SEIKO-SEIKI Rotary Vane >> Shaft Seal >> Installation

Shaft Seal: Installation

  1. Using refrigerant oil, lubricate shaft seal lips and outer "O" ring. Using Seal Remover/Installer (09991-06050) and hand pressure, install shaft seal into front head with shaft seal "O" ring toward compressor. Using refrigerant oil, lubricate Shaft Seal Protector (09991-06040) and install over compressor shaft.
  2. Install compressor housing "O" ring to compressor housing. Align compressor front head with compressor housing and install. Tighten front head bolts "A" first and then front head bolts "B" in a crisscross pattern. See Figure. Tighten bolts "A" to 10 ft. lbs. (13 N.m) and bolts "B" to 17 ft. lbs. (23 N.m). Remove shaft seal protector. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals