LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2000 >> Spectra GS, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> HALLA HS-15 & HALLA HS-18 >> Shaft Seal >> Installation

Shaft Seal: Installation

  1. Lubricate shaft seal protector and shaft seal with refrigerant oil. Install shaft seal on shaft seal protector so lip seal is toward compressor (large end of shaft seal protector).
  2. Install shaft seal protector on compressor shaft. Using shaft seal installer, push shaft seal down seal protector until seal is seated.
  3. Remove shaft seal installer and protector. Install a new shaft seal snap ring and shaft seal felt. Install shim(s) and clutch plate. SeeFig 1. Install clutch hub retaining bolt and tighten to 7-11 ft. lbs. (10-15 N.m). Ensure clutch coil gap is 0.014-0.026" (0.35-0.65 mm).
Fig 1: Exploded View Of Compressor (Halla HS-15)
G00037183Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals