Output Shaft Seal: Notes

WARNING: This page is about a different car, the 2025 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL

Remove the transfer case. Refer to MPT3028C TRANSFER CASE, REMOVAL AND INSTALLATION .
Remove and discard the output shaft seal with a suitable screw and slide hammer.

Courtesy of CHRYSLER GROUP, LLC

1 - Output Shaft Seal

INSPECTION AND CLEANING

Cleaning

Clean and inspect the seal sealing surface.

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

Using the (special tool #2054000210, Installer, Seal Output Shaft), install a NEW output shaft seal.
Check the transmission fluid level and add as necessary. Refer to CHECK FLUID LEVEL .