When Monitored
WARNING: This page is about a different car, the 2025 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
This diagnostic runs continuously when the following conditions are met:
Condition 1:
- Current state of operating mode logic not in state separation clutch open and combustion engine on and powertrain open
- Current state of operating mode logic not in state separation clutch open and combustion engine on and powertrain closed
- Target state of operating mode logic not in state separation clutch closed and combustion engine on and powertrain open
- Target state of operating mode logic not in state separation clutch closed and combustion engine on and powertrain closed
- No fault detected with the combustion engine speed signal.
- No fault detected with the electric motor speed signal.
- Separation clutch status is open.
- Separation clutch torque is less than or equal to a calibrated value.
- Combustion engine torque is less than or equal to a calibrated value.
- Combustion engine speed is greater than or equal to a calibrated value.
- Combustion engine speed is less than or equal to a calibrated electric motor speed.
- Combustion engine speed gradient is greater than or equal to a calibrated value.
Condition 2:
- Current of the separation clutch is greater than a calibrated value.
- Transmission is in DRIVE or REVERSE.
- Electric motor speed minus combustion engine speed greater than a calibrated value.