Set Condition
WARNING: This page is about a different car, the 2025 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- The difference between the input speed measured by the Transmission Control Module (TCM) and both of the following signals are greater than a calibrated value for a calibrated amount of time when there is no electrical or rationality failures of the Output Speed Sensor and no shifting is in progress:
- The calculated input speed from the wheel speed signal from the CAN.
- The calculated input speed from the output speed measured by the TCM.
- The Input shaft direction is not rational or out of range:
- The pulse width of the Intermediate Shaft Speed Sensor A is direction signal is out of range and there is no failure detected for Intermediate Shaft Speed Sensor A circuit high.
- The Intermediate Shaft Speed Sensor A is not rational and there is no failures detected for Intermediate Shaft Speed Sensor A circuit low or Sensor Supply voltage.