LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2025 >> Grand Cherokee Altitude, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (2.0L - Engine (Service Information) (4 Of 4)) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

WARNING: This page is about a different car, the 2025 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine oil pressure and temperature sensor. Refer to: ENGINE SENSORS, REMOVAL AND INSTALLATION .
  2. Install the Engine Oil Pressure Adapter [special tool # 10282] and the Oil Pressure Gauge [special tool # C-3292A].
    GC0181592Courtesy of CHRYSLER GROUP, LLC
    1 - Engine Oil Pressure Adapter [special tool # 10282]
    2 - Oil Pressure Gauge [special tool # C-3292A]
  3. Start the engine and record the reading on the oil pressure gauge.
    NOTE:

    If the oil pressure is 0 at idle, shut off the engine. 

  4. After the check is complete, remove the oil pressure gauge and the adapter.
  5. Install the engine oil pressure and temperature sensor. Refer to: ENGINE SENSORS, REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals