LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2025 >> Grand Cherokee Altitude, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Hybrid Control Processor Module (HCP) - DTCS P2184-00 To P25BA-00) >> DTC Troubleshooting >> P2535-00 Ignition Switch On/Start Position Circuit High >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2025 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Possible Causes
IGNITION RUN/START OUTPUT CIRCUIT BETWEEN RUN/START RELAY AND POWER INVERTER MODULE (PIM) SHORTED TO VOLTAGE
RUN/START RELAY IS STUCK ON (INTERNAL TO POWER DISTRIBUTION CENTER)
POWER INVERTER MODULE (PIM)

Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to  PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE  . 

scientia non olet · About LEMON Manuals