LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2025 >> Grand Cherokee Altitude, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Hybrid Control Processor Module (HCP) - DTCS P2184-00 To P25BA-00) >> DTC Troubleshooting >> P2532-00 Ignition Switch Run Position Circuit High >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2025 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Possible Causes
IGNITION RUN CIRCUIT BETWEEN RUN RELAY AND PIM SHORTED TO VOLTAGE
IGNITION RUN RELAY IS STUCK ON (INTERNAL TO POWER DISTRIBUTION CENTER (PDC)
POWER INVERTER MODULE (PIM)

Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to  PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE  . 

scientia non olet · About LEMON Manuals