LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2025 >> Compass Trailhawk >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 2.0L Engine (Service Information) (3 Of 4) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

  1. Remove the engine oil pressure and temperature sensor. Refer to: ENGINE OIL PRESSURE AND TEMPERATURE SENSOR - REMOVAL AND INSTALLATION .
  2. Install the Engine Oil Pressure Adapter [special tool # 10282] and the Oil Pressure Gauge [special tool #C-3292A].
    GC0181592Courtesy of CHRYSLER GROUP, LLC
    1 - Engine Oil Pressure Adapter
    2 - Pressure Gauge
  3. Start the engine and record the reading on the oil pressure gauge.
    NOTE:

    If the oil pressure is 0 at idle, shut off the engine. 

  4. After the check is complete, remove the oil pressure gauge and the adapter.
  5. Install the engine oil pressure and temperature sensor. Refer to: ENGINE OIL PRESSURE AND TEMPERATURE SENSOR - REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals