Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA 

1. With the scan tool, read ORC DTCs and record on the repair order.
2. With the scan tool, run a Vehicle Scan Report or record the Environmental Data.
   WARNING:

   Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

   WARNING:

   If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.

   Repair 

   • Replace the ORC module according to the Service Information. Refer to CONTROLLER, OCCUPANT RESTRAINT (ORC), REMOVAL AND INSTALLATION .
   • Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .