Torque Specifications - Cylinder Head

WARNING: This page is about a different car, the 2024 Jeep Grand Wagoneer L and 2024 Jeep Grand Wagoneer. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

TORQUE SPECIFICATIONS - CYLINDER HEAD

CALLOUT	DESCRIPTION	SPECIFICATION	COMMENT
1 3	Valve Cover to Cylinder Head Stud Bolts Valve Cover to Cylinder Head Bolts	12 N.m (9 Ft. Lbs.) in sequence	Tighten in sequence (Stud bolts in positions 8, 14, 17, 23 and 24) Courtesy of CHRYSLER GROUP, LLC
1 3		12 N.m (9 Ft. Lbs.) in sequence
2	Camshaft Cap Bolts	Torque Procedure: Step 1 - Hand tighten all bolts in sequence Step 2 - Torque bolts to 11 N.m (8 Ft. Lbs.) in sequence	Tightening Sequence Courtesy of CHRYSLER GROUP, LLC
4	Cylinder Head to Engine Block	Torque Procedure: Step 1 - Tighten bolts to 35 N.m (26 Ft. Lbs.) in sequence Step 2 - Tighten bolts to 55 N.m (41 Ft. Lbs.) in sequence Step 3 - Verify all bolts are torqued to 55 N.m (41 Ft. Lbs.) in sequence Step 4 - Using a torque angle gauge, torque all bolts an additional 150° in sequence	Tightening Sequence Use NEW bolts. Courtesy of CHRYSLER GROUP, LLC