Pressure Bleeding
During the brake bleeding procedure, be sure the brake fluid level remains close to the FULL level in the master cylinder fluid reservoir. Check the fluid level periodically during the bleeding procedure and add brake fluid as required.
A scan tool must be used for brake system bleeding.
For Mopar brake fluid information. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .
Follow the manufacturers instructions carefully when using pressure equipment. Do not exceed the tank manufacturers pressure recommendations. Generally, a tank pressure of 15-20 psi is sufficient for bleeding.
Fill the bleeder tank with recommended fluid and purge air from the tank lines before bleeding.
Do not pressure bleed without a proper master cylinder adapter. The wrong adapter can lead to leakage, or drawing air back into the system.
Using the scan tool, and a pressure bleeding tool, perform the brake fluid bleed routine.