LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2024 >> Wagoneer Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (3.0L - Engine (Service Information) (3 Of 5)) >> Cylinder Head >> Cylinder Head Assembly >> Disassembly And Assembly >> Disassembly And Assembly - On Vehicle >> (Torque Specifications - Cylinder Head)

(Torque Specifications - Cylinder Head)

WARNING: This page is about a different car, the 2024 Jeep Grand Wagoneer L and 2024 Jeep Grand Wagoneer. However, it is still accessible from the selected car via links, so may be relevant.
GC0205396Courtesy of CHRYSLER GROUP, LLC
CALLOUT DESCRIPTION SPECIFICATION COMMENT
1
3		 Valve Cover to Cylinder Head Stud Bolts
Valve Cover to Cylinder Head Bolts		 12 N.m (9 Ft. Lbs.) in sequence  Tighten in sequence
(Stud bolts in positions 8, 14, 17, 23 and 24)
GC0205185Courtesy of CHRYSLER GROUP, LLC
 
2 Camshaft Cap Bolts Torque Procedure: 
  • Step 1 - Hand tighten all bolts in sequence 
  • Step 2 - Torque bolts to 11 N.m (8 Ft. Lbs.) in sequence 
 Tightening Sequence
GC0204225Courtesy of CHRYSLER GROUP, LLC
4 Cylinder Head to Engine Block Torque Procedure: 
  • Step 1 - Tighten bolts to 35 N.m (26 Ft. Lbs.) in sequence 
  • Step 2 - Tighten bolts to 55 N.m (41 Ft. Lbs.) in sequence 
  • Step 3 - Verify all bolts are torqued to 55 N.m (41 Ft. Lbs.) in sequence 
  • Step 4 - Using a torque angle gauge, torque all bolts an additional 150° in sequence 
 Tightening Sequence
Use NEW  bolts.
GC0204212Courtesy of CHRYSLER GROUP, LLC
scientia non olet · About LEMON Manuals