Rear Output Shaft Seal: Notes

REMOVAL 

1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
2. Remove the rear driveshaft. Refer to REAR DRIVESHAFT, REMOVAL AND INSTALLATION .
3. Remove the output flange nut.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Output Flange Nut

4. Remove the output flange from the transfer case with the O-ring seal.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Output Flange

5. Using a suitable tool, remove the output flange seal and DISCARD  .

   Courtesy of CHRYSLER GROUP, LLC

   1 - Output Flange Seal

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Use tool (special tool #9672, Installer, Seal) to install the output flange seal.
• Place the O-ring seal on the output shaft and install the pinion flange.
• If necessary, fill the transfer case to the proper fluid level. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .