LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2024 >> Grand Cherokee Summit >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Hybrid Control Processor Module (HCP) - DTCS P2613-00 To P2E75-00) >> DTC Troubleshooting >> P2BA3-00-Starter/Generator Mechanical Performance >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes
OTHER HYBRID CONTROL PROCESSOR (HCP) DTCS
CONTAMINATED SERPENTINE BELT OR PULLEYS
SERPENTINE BELT SLIPPAGE
BELT TENSIONER NOT PROVIDING ENOUGH TENSION ON SERPENTINE BELT

Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to  PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE  . 

scientia non olet · About LEMON Manuals