Diagnostic Test
CHECK FOR AN ACTIVE DTC
On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.
Read the HIGH-VOLTAGE SAFETY PROCEDURES. Refer to HIGH VOLTAGE SAFETY PROCEDURES .
When the HIGH-VOLTAGE POWER-DOWN PROCEDURE is necessary. Refer to HIGH VOLTAGE POWER DOWN .
- With the scan tool, read Battery Pack Control Module (BPCM) DTCs and record on the repair order.
- Record the Freeze Frame Data (If available), Event Data (If available), and Environmental Data.NOTE:
Verify 12 volt battery is fully charged and no system voltage low or high DTCs are present. If so, perform diagnostic test and recheck operation.
- With the scan tool, erase DTCs.NOTE:
Most BPCM DTCs will require the EVSE to be disconnected in order to clear.
- Using the recorded data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read BPCM DTCs.
Did the DTC return?
Yes
- Replace the Primary and Secondary High Voltage Battery Packs in accordance with the Service Information. Refer to HIGH VOLTAGE BATTERY, REMOVAL AND INSTALLATION .
- Perform the BATTERY PACK CONTROL MODULE (BPCM) VERIFICATION TEST. Refer to HV VERIFICATION TEST .
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .