Section 16 (8P75PH Automatic Transmission - DTCS P0716-00 To P07E4-00)

• DTC Troubleshooting
  • P0716-00-Input Shaft Speed Sensor 1 Performance
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0721-00-Output Shaft Speed Sensor Circuit Performance
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0729-00-Gear 6 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0731-00-Gear 1 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0732-00-Gear 2 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0733-00-Gear 3 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0734-00-Gear 4 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0735-00-Gear 5 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P075B-00-Shift Solenoid "G" Performance/Stuck Off
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P076F-00-Gear 7 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P077C-00-Output Shaft Speed Sensor Circuit Low
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P077D-00-Output Shaft Speed Sensor Circuit High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P077E-00-Transmission Fluid Temperature - Multiple Sensor Correlation
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • P07B3-00-Park Switch 1 Circuit Low
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07B4-00-Park Switch 1 Circuit High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07B9-00-Park Switch 2 Circuit Low
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07BA-00-Park Switch 2 Circuit High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07C5-00-Intermediate Shaft Speed Sensor "A" Circuit Low
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07C6-00-Intermediate Shaft Speed Sensor "A" Circuit High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07D9-00-Gear 8 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07E4-00-Unable To Engage Park
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test