Set Condition
WARNING: This page is about a different car, the 2024 Jeep Grand Cherokee L. However, it is still accessible from the selected car via links, so may be relevant.
- C053D - The PCM determines that the Brake Pedal Pressure Sensor signal is irrational.
- C10F5 - The PCM determines that the Brake Torque signal is irrational.
- P057B - The PCM determines that the Brake Pedal Position Sensor signal is irrational.
- U0121 - The PCM does not receive the Brake Pedal Position Sensor signal.
- U0129 - The PCM does not receive the Brake Pedal Pressure Sensor signal.
- U0418 - The PCM receives an SNA message indicating that the has detected a fault in the Brake Pedal Pressure Sensor signal.
- U11BF - The PCM receives an SNA message indicating that the has detected a fault in the Brake Pedal Position Sensor signals
- (C0501, C0507, C050D, C0513) Wheel Speed Signal Rationality Faults - When at a stop, one WSS signal is showing vehicles speed output and the other three WSS signals are reading 0 OR When the difference between one WSS signal compared to the other three WSS signals is more than 11 MPH, for 30 seconds.
- (U1409, U140A, U140B, U140C, U1412, U1417, U1418) Implausible Wheel Speed and Distance Signal Faults - These faults will typically set when the BSCM detects a fault with one of the WSS signals. The BSCM will send an SNA or error flag against the sensor.
The (P057B, C053D, C10F5, U0418, U11BF) performance and implausible/lost message faults can set for any of the following: