Section 94 (8P75PH Automatic Transmission - DTCS P0985-00 To P1B14-00)

• DTC Troubleshooting
  • P0985-00-Shift Solenoid 5 Control Circuit Low
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0986-00-Shift Solenoid 5 Control Circuit High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0B09-00-Auxiliary Transmission Fluid Pump 1 Motor Supply Voltage Circuit/Open
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0B0D-00-Electric/Auxiliary Transmission Fluid Pump Motor Control Module
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0C1D-00-Electric/Auxiliary Transmission Fluid Pump Control Module Internal Temperature Sensor Circuit Range/Performance
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0C1E-00-Electric/Auxiliary Transmission Fluid Pump Control Module Internal Temperature Sensor Circuit Low
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0C1F-00-Electric/Auxiliary Transmission Fluid Pump Control Module Internal Temperature Sensor Circuit High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0C2C-00-Electric/Auxiliary Transmission Fluid Pump Control Module Feedback Signal Range/Performance
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0C2D-00-Electric/Auxiliary Transmission Fluid Pump Control Module Feedback Signal Low
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0C2E-00-Electric/Auxiliary Transmission Fluid Pump Control Module Feedback Signal High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1500-00-Ecu Configuration Mismatch
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • P1614-00-Ecu Reset/Recovery Occurred
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1625-00-Park Pawl System Failure
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1634-00-TCM Internal - Internal Watchdog Performance
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P167A-00-Calibration Mismatch
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P16F1-00-Internal SPI Communication
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1731-00-Incorrect Gear Engaged
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1778-00 - Input/Turbine Shaft Speed Sensor "A" Out Of Range High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P177F-00-Output Shaft Speed Sensor Out Of Range High
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1B13-00-Park-By-Wire - Unintended Out Of Park Position
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1B14-00-Park-By-Wire - Unintended Park Position
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test