LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2024 >> Grand Cherokee Altitude X, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (2.0L - Engine (Service Information) (3 Of 4)) >> Engine Block >> Standard Procedure >> Connecting Rod Side Clearance Check >> Dial Indicator

Dial Indicator

WARNING: This page is about a different variant/trim than selected.
  1. Mount a dial Indicator to a stationary point on the engine. Locate the probe perpendicular to and resting against the connecting rod cap being checked.
  2. Move the connecting rod all the way to the rear of its travel.
    GC0182750Courtesy of CHRYSLER GROUP, LLC
    1 - Dial Indicator
  3. Zero the dial indicator.
  4. Move the connecting rod forward to the limit of travel and read the dial indicator. Compare the measured side clearance to the specification. Refer to TECHNICAL SPECIFICATIONS .
  5. Repeat this procedure for each connecting rod. Rotate the crankshaft for connecting rod accessibility.
scientia non olet · About LEMON Manuals