Section 19 (Hybrid Control Processor Module (HCP) - DTCS P1B08-00 To P1C8F-00)
WARNING: This page is about a different variant/trim than selected.
- DTC Troubleshooting
- P1B08-00-MCPB High Voltage Battery System Voltage Low
- P1B0F-00-Drive Motor A Position Sensor Offset Incorrect
- High Voltage Warning
- Theory Of Operation - Motor A And Motor B
- Motor A And Motor B Low Voltage (Resolver) Connector Pin-Out (Motor Side)
- Drive Motor A-Motor Resolver-Motor Phase-Motor Temperature Sensor-Resistance Values
- Preliminary Diagnostic Checks
- Check For An Active Or Intermittent Condition
- Enabling Conditions And Possible Causes - Motor A Resolver
- Motor A Resolver Resistance Diagnostic Test
- HV Verification Test
- P1B2D-00-OBCM Controlled System Shutdown
- P1B72-00-Electric Coolant Heater Temperature Outlet Sensor Performance
- P1B73-00-Electric Coolant Heater Temperature Inlet Sensor Performance
- P1C64-00-Hybrid PERF - Engine Speed Below Target During AUTOSTART
- P1C65-00-Hybrid PERF - Engine Speed Target Not Achieved During AUTOSTART
- P1C68-00-Hybrid PERF - Engine Speed Above Target Idle Speed During AUTOSTOP
- P1C8E-00-Power Supply 1 Circuit Low
- P1C8F-00-Power Supply 1 Circuit High