Transmission Oil Cooler Line Jumper: Notes

REMOVAL 

1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
2. Remove the transmission skid plate. Refer to PHEV - TRANSMISSION SKID PLATE .
   NOTE:

   Plug and seal the ends of the transmission oil cooler fittings and the transmission oil cooler lines to prevent leakage of oil, or moisture, contaminates, or impurities from entering into the system.

3. Clean any dirt or debris from the areas of the transmission oil cooler line jumper fittings.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Transmission Oil Cooler Line Bolt

   2 - Transmission Oil Cooler Line Quick-Connect End

   3 - Transmission Oil Cooler Line Jumper

4. Remove the transmission oil cooler line bolt and separate the hose from the transmission.
5. Using (special tool #9546, Disconnect Tool), release the transmission oil cooler jumper hose quick connect end from the transmission and remove the hose from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Check the transmission fluid level. Refer to CHECK FLUID LEVEL  .