Output Shaft Seal: Notes
WARNING: This page is about a different variant/trim than selected.
REMOVAL
- Remove the transfer case. Refer to MPT3028C - PHEV .
- Remove and discard the output shaft seal with a suitable screw and slide hammer.
1 - Output Shaft Seal
INSPECTION AND CLEANING
Cleaning
- Clean and inspect the seal sealing surface.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Using the (special tool #2054000210, Installer, Seal Output Shaft), install a NEW output shaft seal.
- Check the transmission fluid level and add as necessary. Refer to CHECK FLUID LEVEL .