LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2024 >> Grand Cherokee Altitude X, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (2.0L - Engine (Service Information) (4 Of 4)) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine oil pressure and temperature sensor. Refer to ENGINE SENSORS, REMOVAL AND INSTALLATION .
  2. Install the (special tool #10282, Adapter, Engine Oil Pressure) and the oil pressure gauge (special tool #C-3292A, Gauge, Pressure).
    GC0181592Courtesy of CHRYSLER GROUP, LLC
    1 - Engine Oil Pressure Adapter
    2 - Pressure Gauge
  3. Start the engine and record the reading on the oil pressure gauge.
    NOTE:

    If the oil pressure is 0 at idle, shut off the engine.

  4. After the check is complete, remove the oil pressure gauge and the adapter.
  5. Install the engine oil pressure and temperature sensor. Refer to ENGINE SENSORS, REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals