Theory Of Operation

WARNING: This page is about a different car, the 2024 Jeep Grand Cherokee L. However, it is still accessible from the selected car via links, so may be relevant.

The purpose of the diagnostic is to monitor if the hard-wired ignition signal state is equal to the ignition signal state received on the Controller Area Network (CAN) Bus. The CAN message is sent by the Body Control Module (BCM) to the Transmission Control Module (TCM).

A low battery State Of Charge (SOC) or a charging system that is not operating properly can cause many symptoms and DTCs to set.
If possibly related to the customer complaint, check the vehicle charging system and battery for proper operation . Refer to the appropriate Service Information.