Right Catalytic CONVERTOR Heat Shield: Notes
WARNING: This page is about a different car, the 2024 Jeep Grand Cherokee L. However, it is still accessible from the selected car via links, so may be relevant.
REMOVAL
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the right catalytic convertor assembly. Refer to RIGHT CATALYTIC CONVERTER .
- Remove the heat shield bolt, nuts and the right catalytic convertor heat shield.
1 - Heat Shield Nuts 2 - Heat Shield 3 - Heat Shield Bolt
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Start the engine and inspect for exhaust leaks. Repair the exhaust leaks as necessary.