LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Wagoneer Carbide, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (5.7L - DTCS P0602 To P0653) >> DTC Troubleshooting >> P0602-Control Module Programming Error/Not Programmed >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CONTROL MODULE PROGRAMMING ERROR 

NOTE:

Controller is programmed with generic software and will not allow the correct vehicle Powertrain management.

  1. With the scan tool.
  2. Record the vehicles controller part number.
  3. Select Use Controller Part Number under the Flash Tab.
  4. Flash the controller with the correct software.

    Verify the controller flashed successfully.

    Test Complete